WS Wheat wagon now available priced at AUD$39.95.
This kit has been designed to instruct the modeller on how to use low melt solder. The instructions are very detailed with many photos illustrate important points in low melt soldering technique. An extract from the instructions follows: -

Step 1
Now that everything is on hand, its time to make a start. The first step is clean all the parts with detergent and your old toothbrush and then dry them off with a towel. Next step is to clean up the four lower curved angles on each side. As seen in first photo of the assembly sequence, the casting has been extended to allow for the detail to be cast in. Now it time to clean it up, but for the same reason that these webs were included to start with, their removal will make the remaining curved angles delicate and prone to damage so take care.